| POWER SOURCE |
100 – 240 V AC, 50/60Hz |
| RATED OUTPUT |
60 W |
| POWER/CURRENT CONSUMPTION |
96 W (Rated output), 40 W (based on EN62368),
200 mA or less (when power switch is OFF) |
| FREQUENCY RESPONSE |
50 Hz – 20 kHz ±3 dB (1/8 rated output) |
| DISTORTION |
1 % or less at 1 kHz, rated power (20 kHz LPF (AUX-0025)) |
| TONE CONTROL |
Bass: ±10 dB at 100 Hz
Treble: ±10 dB at 10 kHz |
| S/N RATIO |
88 dB or more (Master volume: min.)
76 dB or more (Master volume: max.)
55 dB or more (INPUT 1 – 6)
72 dB or more (INPUT 7)
(A-weighted) |
| AUDIO INPUT |
INPUT 1, 2: -60 dB(*1)(MIC) / -20 dB (*1) (LINE) selectable, 600 Ω, electronically-balanced, removable terminal block (5 pins)/ø 6.3 mm phone jack (2P)
Note: MIC inputs are equipped with phantom power (24V DC, ON/OFF switchable)
INPUT 3: -60 dB(*1), 600 Ω, electronically-balanced, ø 6.3 mm phone jack (2P)
INPUT 4: -60 dB(*1)(MIC) / -20 dB (*1) (LINE) selectable, 600 Ω, electronically-balanced, ø 6.3 mm phone jack (2P)
INPUT 5: -20 dB (*1), 10 kΩ, unbalanced, RCA pin jack x 2
PWR AMP IN: 0 dB (*1), 600 Ω, unbalanced, RCA pin jack |
| AUDIO OUTPUT |
Speaker out: Low impedance (8 – 16 Ω) /
High impedance (DIRECT, ZONE 1, ZONE 2: 100 V / total 170 Ω), removable terminal block (6 pins)
(ZONE 1 / ZONE 2 is selectable, max. 60 W per output)
Rec out: 0 dB(*1), 600 Ω, unbalanced, RCA pin jack
Line out 1, 2: 0 dB (*1) , 600 Ω, unbalanced, RCA pin jack (Interlock with zone selection is possible) |
| CONTROL INPUT |
2 channels. no-voltage make contact input, open voltage: 35 V DC or less,
Short circuit current: 10 mA or less, removable terminal block (5 pins)
ZONE CONTROL IN: No-voltage make contact input, even voltage: 35 V DC or less,
short-circuit current: 10 mA or less, removable terminal block (4 pins) |
| CONTROL OUTPUT |
POWER REMOTE OUT: Open collector output, withstand voltage: 30 V DC or less, control current: 25 mA or less, removable terminal block (4 pins)
EMERGENCY OUT: Open collector output, withstand voltage 30 V DC or less, control current: 25 mA or less, removable terminal block (4 pins)
ZONE CONROL OUT: Open collector output (polarized), withstand voltage 30 V DC or less, control current: 25 mA or less, removable terminal block (4 pins) |
| INDICATOR |
5-point LED output level meter, Power LED, Priority LED, Emergency LED, Thermal protection LED, Over current protection indicator LED, Zone 1 LED, Zone 2 LED |
| OPERATING TEMPERATURE |
-10°C to +40°C |
| OPERATING HUMIDITY |
85 %RH or less (no condensation) |
| FINISH |
Panel: ABS resin, black
Case: Surface-treated steel plate, black, paint |
| DIMENSIONS |
420 (W) × 96.1 (H) × 313.1 (D) mm |
| WEIGHT |
4.9 kg |
